CoffeeDev

I am sure you probably could get FL Studio to run as well with some time and research.

My main troubles with Wine were when I tried to get Roblox to run under it. It ran, but only barely, and I don't quite know why, but I had to use Grapejuice to get it to run without feeling like it was running on a low-end computer from 2005.

I was thinking someone could make a firmware like Tasmota but for printers that can be installed on many existing printers, and a company could make a printer that runs that is designed to run that firmware just like how you can get smart home devices designed to run Tasmota. Also, we just need printers that properly support IPP.

Wine can be difficult to get working right (I have tried to use Wine for a few things before and I also had issues with it that I couldn't solve), so it doesn't surprise me that it doesn't work right for you. It is a miracle that they can get any apps to run on a completely different operating system, and audio software tends to be very complicated and often depends on system APIs.

I wonder if even just an open source firmware for printers could work.

I have a Brother printer that barely works with anything, but on Linux it works perfectly fine.

It looks like at least FL Studio can work with Wine, but you have to use ASIO for audio.

I think music production software uses some system APIs that might not even be possible to replicate with Wine or Proton.

I do not believe there is any way to change it without connecting directly to the device's circuitry, and in some widgets it may even be stored in the ROM, so a Flipper Zero would not be of much help (unless the board has some sort of programming interface you could connect to the Flipper Zero).

I tried all three and I am liking ThinkSocial (I usually read the whole contents of posts and some of the comments so it works pretty well for me). Perchance you know of any desktop (web) clients that have a paginated timeline?

I am also looking at either getting an FDM or SLA printer, but I am more wondering about the cost of materials than the print quality (most of my projects are small but do not require much detail - they are mechanisms that do not need to be super precise, just printed well enough that components fit) and I have heard that the resin used for SLA is much more expensive than FDM filament. I was wondering to what extent that price difference is.