homeassistant

12129 readers

15 users here now

Home Assistant is open source home automation that puts local control and privacy first. Powered by a worldwide community of tinkerers and DIY enthusiasts. Perfect to run on a Raspberry Pi or a local server. Available for free at home-assistant.io

founded 2 years ago

MODERATORS

GreatAlbatross@feddit.uk

case for esp 32 (lemmy.ml)

submitted 8 months ago by GravitySpoiled@lemmy.ml to c/homeassistant@lemmy.world

16 comments fedilink hide all child comments

What do you use as a case for the esp32? I can't find premade ones for it

you are viewing a single comment's thread
view the rest of the comments

[–] sporks_a_plenty@lemmy.world 2 points 8 months ago (1 children)

I ran into the same with the "D1 Mini". The few cases available were expensive for what they were and not a great fit for my needs.

If you have access to a 3D printer, there are some pretty good models on thingiverse and printables. But YMMV depending on which board you're using.

Another possiblity... I wanted to permanently put one in my car, so having some basic protection with the least amount of bulk was important. I ended up buying some shrink tube large enough to go around the entire board (IIRC it was 40mm, 2:1 shrink ratio), got everything wired up, slid the tubing over and shrunk it down. Could probably "double wrap" for more complete coverage. Again, this is board dependent and worked well for the D1 since it doesn't have pre-soldered pins.

Cheers!

[–] GravitySpoiled@lemmy.ml 3 points 8 months ago

That's a great idea 😁 I'll get back to that if I can't get a box