What's the maximum layer height I can achieve on a consumer 3D Printer?
I'm using a bambulab a1 mini more specifically but I'm interested in all answers to that question.
Personally, I think the look of the extrusion can be quite nice if it's not trying to be hidden โ especially with transparent PETG or something similar.
I wouldn't drill a hole. Just buy a set of cheap brass nozzles from Aliexpress or Amazon. They are cheap and available in different sizes or as an assortment of sizes to try. But you have to check if it fits your printer. Afaik there are different styles and lengths of the screw thread that goes inside of the heating block.
You can slow it down if your printer isn't made for this. If you print fast, it has to push through lots of filament through that larger nozzle and heat up lots of it. If you slow down print speed, the flow is less and it might have enough time to keep up.
Since you like that concrete printer: I don't think it has a huge layer height. Judging by the width of those two walls it is printing, I'd say there could be a similar ratio of nozzle diameter and layer height.
If your nozzle is a bit flat at the bottom and not overly pointy, you can print wider walls than the nozzle diameter. It'll squirt out to the sides. Maybe the result looks something like the concrete printer does. Maybe you can combine that with more height, too since it then not lays down a thin line, but it oozes to the sides and that might help with adhesion. I'd try it, worst thing is it doesn't adhere properly to the layer beneath, or lots of molten plastic accumulates at your nozzle and makes a mess.
I'd pay attention to two things: The hotend temperature. If it isn't steady anymore, it struggles with heating the increased amount of filament you're pushing through. Secondly your extruder motor. If it get's hot to the touch, it has to work too hard.