this post was submitted on 22 Jan 2024
309 points (96.7% liked)
Linux
48329 readers
639 users here now
From Wikipedia, the free encyclopedia
Linux is a family of open source Unix-like operating systems based on the Linux kernel, an operating system kernel first released on September 17, 1991 by Linus Torvalds. Linux is typically packaged in a Linux distribution (or distro for short).
Distributions include the Linux kernel and supporting system software and libraries, many of which are provided by the GNU Project. Many Linux distributions use the word "Linux" in their name, but the Free Software Foundation uses the name GNU/Linux to emphasize the importance of GNU software, causing some controversy.
Rules
- Posts must be relevant to operating systems running the Linux kernel. GNU/Linux or otherwise.
- No misinformation
- No NSFW content
- No hate speech, bigotry, etc
Related Communities
Community icon by Alpár-Etele Méder, licensed under CC BY 3.0
founded 5 years ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
Not the installation strictly speaking, but my most "funny" fuckup was setting up xfree86. There was a configuration for crt monitor scan frequency that you had to setup. I messed up something and the monitor started to squeel like crazy and quickly hit hard reset in panic.
The monitor didn't die, but it had a slight high pitch noise to it after.
Back then I was testing modelines to see the maximum I could push to my 14" monitor. I then backed it with a 1200x1600 virtual screen.
My girlfriend got sick from watching me scrolling around and bought me a 19" display which could do that resolution - and ended up frustrated when I added a larger virtual screen.
A 19" monitor was quite big for the day, and expensive! I hope your gf didn't beat you up too much for that :)
I know little about crt because I was born in 2000. Can you explain why did the monitor started to make scary sounds?
I know that crt monitors didn't have any method to report the supported frequency, aside from more recent models, correct?
Yeah, monitors were somewhat dumb, just received and did what the vga output asked to do.
The noise most likely came from the semiconductors that controlled the magnet field that directed the rays onto the screen. These components are selected for a specific speed that the monitor can handle. So going under or over it's spec can make something resonate in the audible range, and could even destroy the components if stressed too much.
The thing is that for each resolution and refresh rate you had two values to configure, one for the vertical speed in Hz, and horizontal speed in kHz. These values were usually specified in the owners manual. Typos can happen, and this was quite a risky operation.
A good starting point for a wikipedia rabbit hole covering the software aspects on how to drive a display: https://en.wikipedia.org/wiki/XFree86_Modeline