1454
Made entirely from 1x2 pine. Ripped into thirds for the shelf slats. Pocket holes. Glue. Brads and glue for the shelf slats.
this post was submitted on 15 Oct 2023
1454 points (99.1% liked)
Woodworking
6155 readers
9 users here now
A handmade home for woodworkers and admirers of woodworkers. Our community icon is a planter box made by @Captain Aggravated, the winner of our summer '24 woodworking contest. Congratulations!
founded 1 year ago
MODERATORS
you are viewing a single comment's thread
view the rest of the comments
view the rest of the comments
I googled and found this post where they tested a similar setup and it failed at 99lbs at 15cm, which looks way way less than the weights you have (plus you’ve got support on two sides, so only like 50% of the load has less support).
I guess the lesson is that the mortise and tenon is very strong, but pocket screws can support a lot of weight too and that’s good enough!
https://woodgears.ca/joint_strength/pockethole.html