Technology

Yeah...kinda left a lot of the layer 1 stuff out of it when I segued into modern ethernet. I could've really ranted.

That was still really close to modern Ethernet when 10BaseT and 10Base2 were out. It was the switched networks and Spanning Tree that really made ethernet win out, by supporting full duplex and scaling way betterer.

Although if I remember correctly, and I could be off because most of this was before my time and I learned from a greybeard who came up on Token Ring...the same physical media for both 10Base2 (the coax with bnc ends, T's at each station, and a terminator on each end) and later 10BaseT (UTP CAT 3, if we are being contemporary) Ethernet did end up getting used for Token Ring as well, just different hardware. And I think IBM was actually able to squeeze more bandwidth out of the same wires for a while, too.

Honestly if not for switched Ethernet and Spanning Tree, Token Ring would've had several more years of life left in it, at least.

Modern 802.11ax (Wifi6) borrows a little bit from the methods of token ring by having the AP essentially schedule timeslots for each of the clients...but it won't make much improvement till most (if not all) of the segment (that is, devices connected to any one radio) is ax or higher. I believe (and don't quote me on this), that is very similar in concept to how the later generation token ring MAUs worked.

You can still do 10Half on some high end managed switches. But most SFPs and mGig ports won't go down that low, and mid-range enterprise access switches are getting fewer and fewer 10/100/1000 ports.

Good. Maybe that means they'll finally upgrade the damn badge readers.